empasa START 2.0 Mode D'emploi page 29

Danger
6A
Pre-drill marked positions with a Ø 12 mm masonry drill bit
approx. 60 mm deep.
Note: The correct type of drill and drill bit (not included)
should be used depending on the surface.
A
Extend side awning .
A
Extend side awning using handle. Insert handle into the base stand
A
retract the awning.
Make sure the handle is seated firmly. Risk of loosening and recoiling.
V2/2019-H038
ø 12 mm
60 mm depth
7A
Remove the screws of the ground sockets
screws into the stand
back on.
Insert the pre-assembled stand
tighten with an Allen key SW 14.
Make sure that the stand
B
B from top to bottom. Proceed in the reverse order to
Installation
B
F
F . Insert the
B . Screw the ground sockets
B into the drilled holes and
B is firmly seated.
A
F
B
29