Installation Instructions - empasa START 2.0 Mode D'emploi

The side awning must be installed with the recommended number of suitable brackets and the specified tension and in
compliance with the manufacturer's instructions.
The combination of surface, mounting material and location can reduce the wind-resistance class of the side awning. Ask another
person to help with the installation if necessary.
1A
Mark drill-hole positions for bracket
Warning! Align bracket C
the side awning.
Danger
2A
Pre-drill marked positions with a Ø 8 mm masonry drill bit
approx. 40 mm deep.
Note: The correct type of drill and drill bit (not included)
should be used depending on the surface.
V2/2019-H038
C
for the side awning
C
exactly perpendicular to each other and level. The distance between the holes depends on the size of
ø 8 mm
B
90°
C
B
A on the masonry.
3A
Insert anchor D . Secure bracket
Make sure the screws are tight.
Note: Other mounting material (not included) may be
required depending on the surface.

Installation instructions

Installation
D
D
C with phillips screws
C
E
C
E
E .
27