Adjusting To The Preferred Gamma Setting (Custom Gamma) - JVC DLA-RS4810 Instructions

Adjusting to the Preferred Gamma Setting (Custom Gamma)

Gamma setting can be adjusted according to your
preferred video quality.
* During 3D signal input and when "Picture Mode" is set
to "3D", gamma setting cannot be adjusted.
Press the [MENU] button to display
1
the menu
Select "Picture Adjust"""Advanced"
2
""Custom Gamma" from the menu
Picture Adjust
Picture Mode
Color Profile
Film 1
Color Temp.
Xenon 1
Gamma Film 1
Dark/Bright Level
Picture Tone
Contrast
0
Brightness
0
Color
0
Tint
0
Reset
Advanced
Exit Operate
MENU Select
.
Select the item to set (Custom 1 to
3
Custom 3), and press the [OK] button.
Picture Adjust
>> Custom Gamma
Custom 1
Correction Value
Custom 2
1023
White
Custom 3
Red
Green
Blue
512
Reset
0 50
Operate
Exit Back
Select BACK
MENU
.
Picture Adjust
> Advanced
Film
MPC Level
NR
Custom Gamma
Color Management Off
User Name Edit
Clear Motion Drive
Off
Lens Aperture
0
Lamp Power
High
Back Exit Operate
BACK MENU Select
D
Gamma Curve
100(%)
Gradation diagram
corresponding to the
gamma curve
Select "Correction Value", and press
the H I keys to select a value for
4
correction to be based on (initial
value)
For details on the correction value, please refer
0
to p. 40.
Normal, A, B, C, D, E, F, G, H, 1.8, 1.9, 2.0, 2.1, 2.2,
2.3, 2.4, 2.5, 2.6
The smaller the value, the brighter the dark
0
areas of the image will become. At the same
time, the bright areas will appear blown out.
The factory settings for Custom 1 to Custom 3
0
are the same as that for the "Normal" setting.
Select the color to adjust, and press
5
the [OK] button
Back
Press the H I keys to select the area
BACK
to adjust (from the 12 points on the
6
gamma curve), followed by using the
JK keys to adjust the brightness
After adjustment is complete, press the [OK]
0
button to confirm the setting.
Selecting "Reset" restores the setting to the
0
initial value (Normal).
Press the [MENU] button to exit
7
41