Use And Maintenance Manual; Description Of Types Of Hobs; Use Of The Burners - La Germania P6401D9X Instructions Pour L'installation

Table des Matières

Publicité

GAS HOB TYPE P640,
GAS HOB TYPE P680,
MIXED SUPPLY HOB P631,
GAS HOB TYPE P650,
GAS HOB TYPE P710,
GAS HOB TYPE P910,
GAS HOB TYPE P950,
GAS HOB TYPE P980,
GAS HOB TYPE P990,
MIXED SUPPLY HOB P981,
GAS HOB TYPE P9C0,
DESCRIPTIVE CAPTION FOR HOB
(Figs. 11A..11M)
1 Auxiliary burner
2 Semi-rapid burner
3 Rapid burner
4 Double crown burner
5 Electric plate
6 Fish burner
7 Front left burner knob
8 Front right burner knob
9 Back right plate switch knob
10 Back left burner knob
11 Back right burner knob
12 Side burner knob
13 Central plate switch knob
14 Ignition button (if provided)
15 Electric plate indicator light
On the control panel above every knob there is a diagram which indicates which burner the knob in question refers to. The burners can
be turned on in several ways according to the type of appliance and its individual features:
- Manual "On" switch ( this is always possible even if the electric current is cut off ): Turn the knob corresponding to the selected
burner in an anticlockwise direction so that the knob is at MAXIMUM (this corresponds to a large flame) and then put a lit match to the
burner.
- Electric "On" switch: Turn the knob corresponding to the selected burner in an anticlockwise direction so that the knob is at
MAXIMUM (this corresponds to a large flame) and then press the lighter button and let it go as soon as the burner is alight..
- Automatic Electric "On" switch: Turn the knob corresponding to the selected burner in an anticlockwise direction so that the knob is
at MAXIMUM (this corresponds to a large flame) and then press in the knob. Let it go as soon as the burner is alight.
- "On " switch for burners with safety device ( thermocouples ): Turn the knob corresponding to the selected burner in an
anticlockwise direction so that the knob is at MAXIMUM (this corresponds to a large flame) and then use one of the lighting devices
described above. When the burner is lit keep the knob pressed in for about 10 seconds in order to allow the flame to heat up the
thermocouple. If the burner goes out when letting the knob go, repeat the operation all over again.
N.B.: You are advised not to try and light a burner if its flame divider is not correctly in place.
Advice for the best use of the burners:
- Use suitable pans for each burner ( see tab. n° 4 and Fig. 12 ).
- When boiling point is reached turn the knob on to MINIMUM.
- Always use pans with a lid.
TABLE N°4: Recommended pan diameters.
BURNER
Auxiliary
Semi-rapid
Rapid
Double crown
ATTENTION: use containers with a flat bottom
ATTENTION: If there is no electric current you can light the burners with matches.
Lighting the burners with safety thermocouples can only be carried out when the knob is on MAXIMUM (large flame) .When
cooking food with oil or fat which can easily set alight, the user must not leave the appliance.
Do not use sprays near the appliance when it is in use. When using the burners make sure that the pan handles are in the
correct position. Keep children away. If the hob has a lid, before closing it, make sure that the surrounding work surface is
cleaned of any food that has been left there.
NOTE: The use of a gas cooking appliance produces heat and humidity in the place where it is installed. Therefore you need to
ensure that the place is well ventilated, keeping clear the natural ventilation openings (Fig. 4 ) and using the mechanical
ventilation device/ flue or electric fan ( Fig. 5A and 5B ). Intensive or prolonged use of the appliance may require additional
entilation such as by opening a window or an increased ventilation efficiency obtained by increasing the power of the
echanical ventilators if it is present.

USE AND MAINTENANCE MANUAL

DESCRIPTION OF HOBS
see Fig. 11A
- Electrical Diagram A
see Fig. 11B
- Electrical Diagram A
see Fig. 11C
- Electrical Diagram C
see Fig. 11D
- Electrical Diagram E
see Fig. 11E
- Electrical Diagram B
see Fig. 11F
- Electrical Diagram B
see Fig. 11G
- Electrical Diagram E
see Fig. 11H
- Electrical Diagram A
see Fig. 11L
- Electrical Diagram B
see Fig. 11M
- Electrical Diagram D
see Fig.11N
- Electrical Diagram E
CAPTION FOR ELECTRICAL DIAGRAM

USE OF THE BURNERS

PAN DIAMETERS recommended (cm.)
11
(Diagrams A..E)
1 Electric panel
2 Lighter button
3 Ignition device
4 Lighting plugs
5 Indicator lights
6 Electric plate
7 Electric plate switch ( 6+0 )
L Brown (phase)
N Blue (neutral)
'
' Yellow/Green (earth)
12 - 14
14 - 26
18 - 26
22 - 26

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

P9101d9x

Table des Matières