Taurus Striker Mini Mode D'emploi page 23

- Clean the equipment with a damp
cloth with a few drops of washing-up
liquid and then dry.
- Do not use solvents, or products
with an acid or base pH such as blea-
ch, or abrasive products, for cleaning
the appliance.
- Do not let water or any other liquid
get into the air vents to avoid damage
to the inner parts of the appliance.
- Do not submerge the appliance in
water or any other liquid, or place it
under a running tap.
- Never submerge the connector in
water or any other liquid or place it
under running water.
Emptying the dust box:
- Empty the dust box each time after
use.
- Open the lid of the dust box. Fig.5
- Disconnect the dust box from the
appliance. (Fig.6)
- Open the dust box emptying lid and
empty its contents into a suitable
rubbish bin (Fig.7)
- Check the condition of the dust box
filter and replace it.
- Close the lid of the dust box.
- Attach the dust box to the applian-
ce.
Changing the filters:
- It is recommended that the dust box
filter should be changed every three
months.
- To remove filters:
- Open the lid of the dust box. (Fig.
5)
- Disconnect the dust box from the
appliance.
- Open the dust box emptying lid and
remove the dust box filter from its
Manual striker mini.indb 23
bracket. (Fig.7)
- To reassemble the filter, proceed
with the above instructions, in reverse
order.
Changing mops:
- To remove the mop.
- Remove the mop holder by carefully
pressing the teeth which secure it
and pulling the holder (Fig.8)
- Pull the mop until it disengages
from the couplings which secure it
(Fig.9)
- To install mops, proceed with the
above instructions in reverse order.
Changing side brushes:
- To remove the side brushes.
- Pull the bristles of the brush until
it disengages from the side brush
assembly. (Fig.10)
- To install side brushes, proceed
with the above instructions in reverse
order.
Supplies:
- Supplies can be acquired from
distributors and authorised establis-
hments (such as filters, etc.) for your
appliance model.
- Always use original supplies, desig-
ned specifically for your appliance
model.
18/03/11 18:00