General Safety Instructions - LaserLiner PowerCross-Laser 8 S Mode D'emploi

Read the operating instructions and the enclosed brochure „Guarantee
!
and additional notices" completely. Follow the instructions they
contain. This document must be kept in a safe place and if the laser
device is passed on, this document must be passed on with it.
High-precision cross-line laser with 8 ultra bright laser lines
and plumb laser
– Homogeneous 360° laser line: The 4 horizontal laser diodes project
a homogeneous laser line. This enables the device to be used like
a rotary laser.
– IR remote control allows the manual slope function for aligning inclines to
be controlled. The relevant axes are visually displayed via LEDs.
– A simple, precise plumb function is afforded by the additional plumb laser
at the bottom and the laser cross at the top.
– Out-Off-Level: is indicated by optical signals when the unit is outside its
self-levelling range.
– Automatic levelling range 3°, accuracy 1 mm / 10 m

General safety instructions

– The device must only be used in accordance with its intended purpose
and within the scope of the specifications.
– Attention: Do not look into the direct or reflected beam.
– Do not point the laser beam towards persons.
– If a person's eyes are exposed to class 2 laser radiation, they should shut
their eyes and immediately move away from the beam.
– Under no circumstances should optical instruments (magnifying glass,
microscope, binoculars) be used to look at the laser beam or reflections.
– Do not use the laser at eye level (1.40 ... 1.90 m)
– Reflective, specular or shiny surfaces must be covered whilst laser devices
are in operation.
12
GB
Laser radiation!
Do not stare into the beam!
Class 2 laser
< 1 mW · 635/650 nm
EN 60825-1:2014