Scene Name; Scene Steps; Add Step; Delete Step - Chauvet Professional NET-X II Mode D'emploi

Scene Name

The Net-X II allows you to customize the name of each scene. To name a scene, do the following:
1. Select the Scene to configure as instructed in
2. Use the knob to select 1. Name:Scene_1–10.
3. Press the knob.
4. Use the knob to select the letter, number or symbol, from A–@. There are 96 options.
5. Repeat until the name is set as desired.
6. Use the knob to select either Enter to save the name, or Cancel to exit without saving.
7. Press the knob.

Scene Steps

This feature displays the amount of steps saved to the scene. To view previously saved steps, follow the
instructions below:
1. Select the Scene to configure as instructed in
2. Use the knob to select 2. Step:(0/0).
3. Press the knob.
4. Turn the knob to cycle through the saved steps.

Add Step

This function adds a step to the scene. To add a step to the scene, do the following:
1. Select the Scene to configure as instructed in
2. Use the knob to select Add Step.
3. Press the knob.

Delete Step

This function deletes a step from the scene. To delete a step from the scene, follow the instructions below:
1. Select the Scene to configure as instructed in
2. Use the knob to select Delete Step.
3. Press the knob.

Timing

This function sets the intervals between steps, as well as a fading effect if desired.
1. Select the Scene to configure as instructed in
2. Use the knob to select 5. Timing.
3. Press the knob.
4. Use the knob to select:
• 2. Fade In Time:0.10S—9M59S.
• Press the knob.
• 3. Fade Out Time:0.10S—9M59S.
• Press the knob.
• 4. Delay Time:0.10—9M59S.
• Press the knob.
• 5. Exit (to cancel).
5. Select 1. Save Step menu option to save timing settings.

Trigger Settings

The Net-X II can assign a trigger to an external dry contact switch to trigger a recorded scene. When the
trigger is turned on, the Trigger Info will display on the display screen with the scene name, amount of
steps, and the timing set for that scene.
1. Use the knob to select 11. Trigger Settings.
2. Press the knob.
3. Use the knob to select Trigger 1–4.
4. Press the knob.
5. Use the knob to select the desired Scene 1–10.
6. Press the knob.
18
Record Scenes.
Record Scenes.
Record Scenes.
Record Scenes.
Record Scenes.
Net-X II User Manual Rev. 3
Operation