Xoro HSD 8430 Manuel D'emploi page 91

Symptons
The remote control
does not work prop-
erly
Y Pb Pr (YUV)
No picture or picture
distortion
(progressive scan)
HDMI
No picture
Picture distorted
during fast forward
or fast reverse
No 4:3 or 16:9 pic-
ture (distorted pic-
ture)
TROUBLESHOOTING
Cause
•
The remote control is not
pointed at the remote sensor
of the DVD player.
•
The remote control is too far
from the DVD player.
•
The batteries in the remote
control are exhausted.
•
The video cable is not con-
nected securely
•
The DVD video mode is not
matched
•
The TV is not set into re-
ceive DVD signal output
•
The video cable is not con-
nected securely
•
The DVD video mode is not
matched with the TV
•
The TV is not set into re-
ceive DVD signal output
•
You had press the >> or <<
button for during fast forward
or fast backward
•
Wrong setting by TV TYPE
Correction
•
Point the remote control at the
remote sensor of the DVD
player.
•
Operate the remote
within about 7 m.
•
Replaced the batteries with new
ones.
•
Connect the video cable into the
jacks securely
•
Set the video output as Progres-
sive scan mode
•
Select the appropriate video
input on the TV so the picture
from the DVD player
•
The TV set may not be compati-
ble with this DVD-Player and
switch to NTSC output or use
CVBS, S-VIDEO or SCART to
connect TV set
•
Connect the video cable into the
jacks securely
•
Set the video output as HDMI
(HD) mode
•
Select the appropriate video
input on the TV so the picture
from the DVD player
•
The TV set may not be compati-
ble with this DVD-Player and
switch to NTSC output or use
CVBS, S-VIDEO or SCART to
connect TV set
•
The picture will be somewhat at
times
•
This is normal advance or re-
verse
•
Press > (Play) button for normal
speed
•
Choose the correct setup at TV
TYPE item that matches the TV
set
control
41