General Power Tool Safety Warnings; Hammer Drill Safety Warnings - Makita M8100 Manuel D'instructions

ENGLISH
(Original instructions)
1 Grip base
2 Teeth
3 Side grip (auxiliary handle)
4 Protrusion
5 Loosen
6 Tighten
SPECIFICATIONS
Capacities
No load speed (min
Blows per minute
Overall length
Safety class
• Due to our continuing program of research and
development, the specifications herein are subject to
change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.

General Power Tool Safety Warnings

WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.

HAMMER DRILL SAFETY WARNINGS

1. Wear ear protectors when impact drilling.
Exposure to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Explanation of general view
7 Drill chuck
8 Chuck key
9 Sleeve
10 Ring
11 Side grip
12 Depth gauge
Model
Concrete
Wood
Steel
–1
)
Net weight
M8100
296 mm
2.1 kg
4. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
5. Hold the tool firmly with both hands.
6. Keep hands away from rotating parts.
7. Do not leave the tool running. Operate the tool
ENE039-1
only when hand-held.
8. Do not
immediately after operation; they may be
extremely hot and could burn your skin.
9. Some material contains chemicals which may be
ENF002-2
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.
SAVE THESE INSTRUCTIONS.
WARNING:
GEA010-1
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
ASSEMBLY
Installing side grip (auxiliary handle) (Fig. 1)
GEB003-5
CAUTION:
• Always be sure that the tool is switched off and
unplugged before installing or removing the side grip.
Always use the side grip to ensure operating safety.
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
13 Switch trigger
14 Lock button
15 Reversing switch lever
16 Action mode changing lever
M8101
16 mm
30 mm
13 mm
0 – 3,200
0 – 48,000
295 mm
2.0 kg
/II
touch the bit or the workpiece
3