During Use - Nidek LE-700 Manuel D'utilisation

During use

WARNING
• Only personnel authorized by NIDEK or a NIDEK distributor are allowed to remove the cover fastening
screws and covers, disassemble, or touch the interior of the instrument.
Electric shock, injury, or malfunction may result.
• Never touch the wheel while it is rotating.
Injury may occur.
• Never open the processing chamber cover during lens processing.
Spray containing processing waste may cause eye damage.
• Be sure to use the instrument only to process spectacle lenses.
If any other materials are processed, injury may occur.
• Do not inhale vapor and particles produced during lens processing. Wear a protective mask, glasses, and
such as necessary.
Vapor or particles may be toxic depending on the materials.
CAUTION
• In the event of smoke or strange odors, immediately turn off the instrument and disconnect the power plug
from the wall outlet. Once it is confirmed that the smoke has stopped, contact NIDEK or your authorized
distributor.
Usage of the instrument under such abnormal conditions may cause fire or electric shock. In case of fire, use a
dry chemical (ABC) extinguisher to extinguish the fire.
• Immediately replace the power cord if the internal wires are exposed, power is intermittent when the
power cord is moved, or the cord and/or plug are hot to the touch.
Electric shock or fire may occur.
• In the event of malfunction, disconnect the power cord from the wall outlet. Never touch the interior of the
instrument and contact NIDEK or your authorized distributor.
Electric shock or fire may occur.
• Be careful not to injure your hand on any sharp edges when removing the processed lens.
The lens edge may cause finger injury.
• Safety bevel the front and rear surfaces of glass lenses after processing.
Subtle burrs may damage one's skin.
• Be careful not to get fingers caught when chucking (securing) a lens, pattern, or calibration jig.
Injury may result.
• Do not splash water into the interior of the instrument. Protect the display from splashing water. Also,
never operate the display with wet hands.
Water seeping into the instrument may result in electric shock, malfunction, or fire.
• Always clean up any spilled water from the pump tank with a clean dry cloth.
A slippery wet floor may cause injury.
• Keep eyes away from spray.
Spray containing processing waste may cause eye damage.
• When removing the lens cup by twisting the cup remover, hold the lens with a soft cloth or such.
If the lens is held directly, hands may be injured by the lens edges.
5