Usage Precautions; Before Use - Nidek LE-700 Manuel D'utilisation

Usage Precautions

Before use

WARNING
• Use a hand cart when moving the instrument. At least two
persons are necessary to lift the instrument.
Failure due to dropping of the instrument, backache, or
stumbling may occur.
• Be sure to lift the instrument by holding it at the points
, , and at the bottom of both sides (see the fig-
ure to the right). Do not lift the instrument by its cover.
Failure to do so may cause the instrument to fall resulting
in injury or malfunction.
• Be careful not to get fingers caught when setting the instru-
ment down.
Fingers may get caught between the table and instrument resulting in injury.
• Set the instrument on a table whose area is larger (50 mm or more) than the outer dimensions of the
instrument as shown below. A table height of 650 to 700 mm is recommended to allow space for the pump
tank to be installed under the table.
Additionally, the table must be sturdy enough to bear the weight of the instrument (33 kg) and be provided
with adjusters on its legs to allow it to be level and stable.
Failure to do so could cause the instrument to fall in the event of impact or accidents.
An opening must be made in the table to pass the pipe through.
Position of instrument rubber foot (three spots)
2-R50
• Install the instrument in a stable and level place where vibration or shock does not occur.
Tilting or vibration can cause the instrument to fall or prevent normal lens processing.
543
3- 50
115
R70
237 242
261
(unit: mm)
269
D
,
C
A height of 650 to 700 mm
recommended
Instrument perimeter
Table perimeter (example)
Opening for drain pipes
Opening for cooling water and cleaning
water pipes
B
A
3