Safety Instructions - ALFRA KFT 500 Notice D'utilisation

1.

Safety instructions

Please read the operating instructions carefully and follow the directions and information contained therein.
When using power tools, follow the safety measures below in order to protect against electric shock, fire and
injury:
Inspect the unit, cable and plug before each use! Do not use the unit if the switch is damaged, if it can no
longer be switched on and off reliably or when the speed controller on the motor is no longer functioning
perfectly.
Insert the plug into the socket only when the motor is switched off.
Never use this unit when it is wet and also not in a damp environment.
Do not use the unit near flammable liquids or gases.
Ensure that the area in which you are working has good lighting.
Always wear safety goggles.
Take care with long hair and hanging jewellery. It can be caught by the rotating motor spindle.
Make sure that you do not touch the cutter.
The work piece being milled must be secured well during work.
Ensure that the power cable is flat on the floor! Avoid tripping up.
Ensure stability when working.
Pull out the mains plug before carrying out any work on the unit and motor.
Protect yourself against electric shocks.
Avoid parts of the body coming into contact with earthed parts.
Do not overload the unit. You can work better and more safely in the stated performance range of the
drive motor.
Use the unit only for its intended purpose.
Do not misuse the electric cable. Never carry the unit by its cable and never pull on the cable to remove
the plug from the socket.
Protect the electric cable against heat, oil, fuel and sharp edges.
Allow only experts to repair damage.
10