Use - Gourmetmaxx Sc-R10A Mode D'emploi

Perform the steps in reverse order to dismantle the device.

Use

PLEASE NOTE!
■ Never operate the device without the heat shield. Make sure that it is fi tted correctly
before operating the device.
• On the central spit you can grill up to 4 kg meat or a whole chicken.
• Make sure the meat is not cut too thickly, so that it fi ts easily on the spit.
• Use the skewers to grill sausages or meat / mixed / vegetarian kebabs.
Grilling döner kebab
1. Cut the meat into slices.
2. Place the slices on the central spit (4) one after the other. Make sure that the slices
of meat do not protrude beyond the edge of the skewer plate.
3. Assemble the device (see the "Assembly" chapter).
4. Insert the plug into a properly installed socket.
5. Switch the device on by moving the On / Off switch (6) to Position I (On). The device
starts to heat up. The operating lamp lights up and the central spit (4) rotates. The
meat is grilled.
If the central spit (4) cannot rotate freely, you should dismantle the device and
assemble it again. Make sure that the retaining bracket (1) is fi tted correctly to the
cog of the central spit (2).
6. When the meat is brown enough, switch the device off by moving the On / Off
switch (6) to Position 0 (Off). Use a sharp knife to cut off the outer layer of the meat,
and catch the meat in a suitable container. Switch the device on again.
Repeat the procedure until all the meat has been grilled.
7. Switch the device off by moving the On / Off switch (6) to Position 0 (Off).
8. Disconnect the device from the mains power after use and allow it to cool down
before you clean it.
05914_DE-EN-FR-NL_neuer_Hersteller_A5_V4b.indb 19 05914_DE-EN-FR-NL_neuer_Hersteller_A5_V4b.indb 19
19
5. Place the cog of the central spit (2) on the upper end of
the central spit (4).
6. Place the longer end of the retaining bracket (1) into the
slit in the rear wall of the device.
7. Place the screw at the other end
8. Tighten the screw to fi x the retaining
of the retaining bracket (1) into the
opening in the clamp on the cog of
the central spit (2). Slide the screw
into position on the right.
bracket (1) into place.
EN
06.11.2017 10:50:35 06.11.2017 10:50:35