Operating The Charger - HITEC RDX2 Pro Notice D'utilisation

Operating the Charger

First, familiarize yourself with the Jog Dial which is the main way you will interact with the charger and
its programming. Turning the Jog Dial allows you to "SCROLL" through the main menus, functions, and to
change parameters. Pushing the Jog Dial in the center allows you to "ENTER" the menu you are choosing.
Once you are in a menu, turn the Jog Dial to SCROLL through to different functions. When you want
to select a function, press the Jog Dial again to ENTER. Once you come upon a value that needs to be
changed, push the Jog Dial to highlight it. The value will now start blinking. To change the value, simply
turn the Jog Dial clockwise to increase, or counterclockwise to decrease. Once you have the proper setting,
press it to store the value. When you are ready to charge, push and hold the Jog Dial down for 3 seconds
to start the charge process.
The MODE/STOP button allows you to "go back." Before you begin charging your first battery, it is recom-
mended that you SCROLL through all the menus and then enter them one by one to get a feel for how the
interface works. Do not forget you will use the MODE/STOP button to revert back. Remember, you can
always reload the factory settings in the System Setting menu under "Load Factory Settings" by pushing
and holding the Jog Dial for 3 seconds. We will use the term "SCROLL" when you will turn the Jog Dial, and
"ENTER" when you will push the Jog Dial. Now... Let's get charging!
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE
YOU HAVE READ AND UNDERSTOOD ALL OF THE WARNINGS
AND SAFETY INFORMATION CONTAINED ON PAGES 4-6.
Warning
Selecting the Battery Type: After powering on the RDX2 Pro, the
charger will display the last charging mode used. Press the MODE/
STOP button to get to the BATT/PROGRAM menu and SCROLL with
the Jog Dial until you reach the battery type you wish to charge.
Press the Jog Dial to access the charge programs.
Lithium Battery Charging: The RDX2 Pro can charge all Lithium
battery types and the programming procedures are identical for
them all. These instructions will use the most common LiPo BATT
(Lithium Polymer) program to walk you through step by step, the set
up for charging Lithium packs.
BATT/PROGRAM LiPo BATT: Battery Type Select: Use the Jog dial
to SCROLL through until you find LiPo BATT. Once there, press the Jog
Dial (ENTER) to select the battery type and access the charging mode
programming.
14
Tip
Press the MODE/STOP button twice
if you are stuck in another menu.
B A T T / P R O G R A M
A
LiPo BATT
LiPo BALANCE
A
2.0A 11.1v (3S)