Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING
1.
Turn off the airflow before beginning replacement.
2.
Push the idle pulley in the A direction (Shown the Figure below)
3.
While doing this, remove the belt from the drive pulley.
4.
Disengage and remove the belt from the idle pulley.
5.
Put on the new belt.
6.
The new belt is placed over the idle pulley first, press down, and then placed
over the drive pulley.
7.
Under this state, remove your hand from the pulley.
8.
Press the tension bar (P in the figure below), the belt will be tensioned.
9.
Make sure the belt is positioned in the direction of the rotation as shown in
the figure below.
1English1
REPLACING THE GRINDING BELT
English
-7
Publicité
Table des Matières
