ACDelco ANS604 Manuel Informations Du Produit page 10

1English1
Do not modify the tool, safety devices, or accessories.
Do not use this tool for purposes other than those recommended.
Note the position of the reversing mechanism before operating the tool so as to
be aware of the direction of rotation when operating the throttle.
Exposed throttles shall not be used where obstructions can hold the throttle in
the "on" position.
Periodically check the drive end of the tool to make certain that the socket
retainer functions correctly, and that sockets and drive ends are not excessively
worn which may allow the socket to come off when rotating.
When a secondary handle is supplied, ensure it is properly installed and use two
hands to maintain control when operating tool.
If the tool is to be with a balancer or other suspension devise ensure that the tool
is firmly attached to the suspension/support device.
To turn off the air supply to the tool and press the on/off valve to exhaust the air
from the feed hose before installing, removing or adjusting any accessory on this
tool.
Do not lay down the tool until the working attachment has stopped moving
completely.
The on/off device is designed in side or outside of the grip. It is a "plug-and-run"
type device. This tool will stop operation/rotation in a few seconds after reliving
the level control.
The speed set up device is indicated by an arrow mark and intergraded with an
indication either marked by "H" (high) and "L" (low) or by "+" (high) and "-"
(low), rotating the knob to desired speed.
Apply the sander lightly to the work and allow the belt to cut.
Take great care when sanding around sharp edges and corners to avoid
snagging and belt damage or breakage.
Do not continue to use belts that are clogged or worn as this will make the
sanding process inefficient and the need to apply unnecessarily high loads to the
tool.
Only use belts of the dimensions specified. To use incorrect belt will either cause
it to break or fly off. Both occurrences could be dangerous.
Do not lock, tape, wire, etc. the on /off valve in the run position. The
trigger/lever etc. must always be free to return to the "off" position when it is
released.
English -9