Lubrication - ACDelco ANS604 Manuel Informations Du Produit

Always use clean, dry air as excessive moisture will lower the available
NOTE
torque and rust the interior moving parts. Make sure all hoses and fittings
are of the recommended size and be sure the tool is not used with more than or less
than the recommended pressure at the tool!
PARTS AND MAINTENANCE INFORMATION
CAUTION
The use of other than genuine ACDelco Tools replacement parts may result in
safety hazards, decreased tool performance and increased maintenance, and
may invalidate all warranties.
Repairs should be made only by authorized trained personnel. Consult your
nearest ACDelco Tools Authorized Service Center.
When the life of the tool (these tools) has expired, it is recommended that the
tool (these tools) be disassembled, degreased and parts be separated by material
so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized
Service Center.
Refer all communications to the nearest ACDelco Tools Distributor.
Proper lubrication of this air tool (these tools) is critical to the operation and life of the
unit. Units can be severely damaged or have excessive wear placed on working parts if
not lubricated.
Before connecting the air hose, it should apply 4 to 5 drops of #60 spindle oil at air
inlet. The repeated oiling after 3 to 4 hours operation will be necessary.
WARNING
objects.
Disconnect the tool (these tools) at its air inlet from the air supply
NOTE
system before any lubrication. Connect the tool (these tools) to an air
supply system and cover the exhaust with a towel and run for a few seconds after
lubrication is finished. Be careful to keep the towel away from moving parts.
1English1
MAINTENANCE

LUBRICATION

Any excess oil in the motor is immediately expelled from the
exhaust port. Always direct exhaust port away from people or
English -12