TEP REPLAY+ Guide Rapide page 34

Learning Keys
There are 4 learning keys
They can be used to learn the codes from your existing
TV remote control: TV-Power, Source,
In this way you only need one single remote control for your
TB and your TV set.
How to learn the codes:
1. Press and hold both
on, the remote is now in the learning mode
2. Press on the button you wish to learn (e.g. Source) until the red LED
flashes
3. Place your original TV remote to point to the new REPLAY+ remote. Make
sure you keep the fronts of the two remotes opposite to each other
within 1 cm.
4. Press and hold the corresponding button (e.g. Source) on your original TV
remote. The red LED light on the new REPLAY+ remote will blink three
times and then stay on to indicate that the learning was successful.
5. Repeat the process for the remaining three learning buttons on your new
REPLAY+ remote.
6. Press both
Try out the newly learned function from your new REPLAY+ remote. If it does not
work as expected, please press a random button and repeat steps 1 - 6.
on the remote marked with USER.
VOL+ and
VOL+ and VOL- buttons again to exit the learning mode.
REPLAY+
VOL+ and VOL-.
VOL- buttons until the red LED light stays
34