Thermador PH Professional Série Instructions D'installation page 4

Parts Included with your Hood
• Hood Canopy
• 12-Volt halogen bulbs, installed
• Filters (2, 3, or 4 depending on model and size)
• Metal Transition with backdraft damper installed
• Fasteners
• Remote Blower ("pigtail") Adaptor
• Wooden Strip for Hood Support
• Wire Nuts
• 2 - 175W PAR-38 Heat Lamps or
2 - 250W PAR-40 Heat Lamps
• Use & Care Manual /Installation Instructions
• Registration Card
CONSIDERATIONS BEFORE INSTALLING HOOD
1. For the most efficient air flow exhaust, use a
straight run or as few elbows as possible.
2. Do not use flex ducting.
3. COLD WEATHER installations should have an
additional backdraft damper installed to
minimize backward cold air flow and a
nonmetallic thermal break to minimize
conduction of outside temperatures as part of
the ductwork. The damper should be on the cold
air side of the thermal break. The break should
be as close as possible to where the ducting
enters the heated portion of the house.
4. Hood installation height above a cooktop or
range can vary. To obtain the necessary
installation height above a Thermador
Professional Cooktop or Range, consult the
appliance's installation manual.
Parts Not Included with your Hood
• Duct Tape
• 1/2" Conduit
• Ventilator- The hood can be installed with
ventilator models VTN1030C, VTR630D,
VTR1030D, VTR1330E, or VTR1530D.
• Optional duct cover, 6" DC**US or 12" DCT**US
height (available for purchase seperately)
** = width of hood
• Optional Remote Control (available for purchase
separately)
* For indoor grill installations, Thermador
recommends a minimum of 36" clearance and
remote blowers only (VTR1030D, VTR1330E, or
VTR1530D).
5. Remote blowers require a five wire installation.
6. Make-Up Air: Local building codes may require
the use of make-up air systems when using
ducted ventilation systems greater than specified
CFM of air movement. The specified CFM varies
from locale to locale. Consult your HVAC
professional for specific requirements in your
area.
7. Refer to Remote Control Installation Instructions
if applicable.
3