Intended Use; Special Safety Instructions - Ayce 3124.1 Traduction De La Notice Originale

INTENDED USE

The machine is intended for making separating cuts and cutouts in wood, plastic,
metal, ceramic plates and rubber while resting firmly on the work-piece. It is suitable
for straight and curved cuts having miter angles of up to 45°.

SPECIAL SAFETY INSTRUCTIONS

1. Hold power tool by insulated gripping surfaces, when performing an operation
where the cutting accessory may contact hidden wiring or its own cord.
Cutting accessory contacting a "live" wire may make exposed metal parts of
the power tool "live" and could give the operator an electric shock.
2. IF YOU ARE NOT thoroughly familiar with the operation of a jig saw, obtain
advice from a qualified person.
3. The jig saw is double insulated. When servicing, use only identical
replacement parts.
4. Wear dust mask.
5. Avoid cutting nails when operate with the wood blade. Inspect the work-piece
carefully and remove all nails and staples before operation.
6. Make sure the blade always extends beyond the shoe and workpiece
throughout the stroke. Blades may shatter if they strike the work piece or
shoe.
7. Do not cut oversized work-piece.
8. Check for proper clearance beyond the work-piece before cutting so the blade
will not strike the floor, workbench, etc.
9. Make sure the blade is not contacting the work-piece before the switch is
turned on.
10. Keep the saw blades clean and sharp.
11. Use only correct blades. Always use blades recommended for the type of
work-piece.
12. Do not leave the tool running. Operate the tool only when hand-held.
13. Always release the switch to OFF and wait for the tool to come to a complete
stop before removing the blade from the work-piece.
14. Keep the handle dry, clean, and free from oil and grease. Always use a clean
cloth when cleaning. Do not use solvents, brake fluids, gasoline or other
petroleum products to clean the tool, they may damage plastic parts.
15. Do not operate this tool in a gaseous or explosive atmosphere or near
explosive materials.
16. Never force the tool. Apply firm pressure against the saw pivot shoe for the
sawing operation--too little or too much pressure could cause jumping,
vibration and break the blade.