Saving, Retrieving And Deleting Results; Cleaning And Storing The Instrument; Rectifying Faults - Beurer medical BC 08 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20

6. Saving, retrieving and deleting results

The computer automatically saves the blood pressure
readings of the last 50 measurements. When the 50 me-
mory locations are exceeded, the current oldest value
is deleted.
You can display the memory as follows:
• Press the „User-Switching key"
memory zone, and press the „M" key to switch from
memory to memory with sequence numbers.
• The saved measured values are continuously stored.
• Press the On/Off switch
• If you forget to switch off the computer, it will switch
off automatically after 1 minute.
Press the „User-Switching key"
mory zone, then press and hold the „M" key for approxi-
mately 5-seconds to clear the data in the pre-designated
memory zone. The data in both memory zones – zone
1 and zone 2 may be erased if any of the batteries is
removed.

7. Cleaning and storing the instrument

• Clean your blood pressure computer carefully using
only a slightly moistened cloth.
• Do not use any detergents or solvents.
• Never hold the instrument under water as otherwise
liquid can penetrate and damage the instrument.
to select a
to turn the unit off.
to select a me-
• Never place any heavy objects on the instrument.

8. Rectifying faults

Error messages can occur when
• the blood-pressure value is unusually high or low („EE"
appears in the display),
• you move or talk during the measurement („EE" ap-
pears in the display),
• the cuff tube is not properly inserted („E1" appears in
the display),
• inflation takes longer than 20 seconds („E1" appears
in the display),
• the inflation pressure is higher than 300 mmHg („E2"
appears in the display),
• an error occurs when storing the measured values
(„E3" appears in the display),
• Exceeding measurement range („Er" appears in the
display).
In the about cases, you must repeat the measurement.
Make sure that the cuff tube is properly inserted and that
you do not move or talk. Put the batteries back in if ne-
cessary, or else replace them.
18

Publicité

Table des Matières
loading

Table des Matières