Cleaning - gourmetmaxx Z 09747 Mode D'emploi

EN

Cleaning

ATTENTION!
■ Burn hazard! Allow the device to cool off completely before you clean it.
■ Danger of electrocution! Prior to each cleaning, pull the mains plug out of the socket.
■ Danger of electrocution! Keep the motor assembly, mains cord and plug away from
water or other liquids! Never touch them with wet hands. The motor assembly is not
suitable for cleaning in the dishwasher.
■ Risk of injury associated with sharp blades! Be very careful when handling the
cross-blade adapter. The cutting blades are extremely sharp. Never touch the blades
with your bare hands. Always hold the cross-blade adapter fi rmly by the top end or
shaft when removing, inserting or cleaning it. Remove it before you clean the mixing
bowl!
■ Do not leave the cross-blade adapter in water or other liquids for more than 2 hours
to prevent damage. It is not suitable for cleaning in the dishwasher.
■ Damage to the device! Do not submerge the mixing bowl in water or other liquids.
No liquid may penetrate the bottom part of the mixing bowl as heating elements and
other electronic components are installed there. Therefore, also do not clean it in the
dishwasher. Briefl y rinse it off under running water.
■ The surfaces could be damaged! Do not use any scouring or abrasive cleaners or
scouring sponges to clean the device. They could damage the surface.
• Immediately clean the mixing bowl and accessories after use to prevent the formation
of germs:
1. Ensure that the product is disconnected from the mains supply!
2. After emptying the mixing bowl, briefl y rinse it under running water.
3. Take the cross-blade adapter and, if used, the stirring adapter or the blade guard
out. For this, follow the instructions in the chapter "Using the accessories properly",
section "Cross-blade adapter".
4. Thoroughly rinse the mixing bowl and cross-blade adapter under running water. You
can use a mild detergent. If necessary, remove the sealing ring from the cross-blade
adapter.
5. If necessary, wipe the motor assembly off with a damp cloth. Dry it off with a soft cloth.
6. You can clean the other accessories in the dishwasher. Clean the sealing ring for the
lid separately.
7. Let all parts dry completely before reassembling them.
8. Store the device in a clean, dry area that is not accessible to children and animals.
If the mixing bowl and cross-blade adapter are only slightly dirty, it is suffi cient to
clean them by briefl y blending them with water. To do so, add 1 litre of water and
a few drops of detergent to the mixing bowl, close it, select speed level 5 or 6 and
push the pulse button a few times. Then rinse it out thoroughly with clean water.
NOTE: The plastic parts may discolour with time. However, this is of no concern with
respect to health or the functioning of the device parts.
09747_de-en-fr-nl_V4.indb 52 09747_de-en-fr-nl_V4.indb 52
52
04.01.2016 16:01:01 04.01.2016 16:01:01