Samsung DV48J7700E Série Mode D'emploi page 23

A
B
F
NOTE
We recommend using ring terminals. If you use strap terminals, please ensure you install
them perfectly.
DV7700J-03170Q-05_EN-US.indd 23
8. Four Wire System instructions:
A. External ground connector
D
B. Green or bare copper wire of power
cord
C. ¾" (1.9 cm) UL-listed strain relief
D. Center silver-colored terminal block
screw
E. Neutral grounding wire (white)
E
F. Neutral wire (white or center wire)
a. Remove the External ground
C
connector screw.
b. Connect the ground wire (green
or unwrapped) of the power cord
to the external ground connector
screw. If you want to connect
B (Green or bare copper wire
of power cord) to the Neutral
Post without connecting it to A
(cabinet ground), call a service
technician.
c. Loosen or remove the center
terminal block screw.
d. Connect the neutral wire (white
or center wire) of the power cord
and the appliance ground wire
(white) under the central screw
of the terminal block.
e. Connect the other wires to the
outer terminal block screws.
Tighten screws.
f. Tighten the strain relief screws.
g. Insert the tab of the terminal
block cover into your dryer's rear
panel slot.
Secure the cover with a hold-
down screw.
English 23
2015/11/3 11:28:05