Velleman WC32TC Mode D'emploi

WC32TC -- MULTIFUNCTIONAL WALL CLOCK
1. Introduction
Thank you for buying the WC32TC. This wall clock does so much more than merely display the
correct time ! This device is also equipped with numerous other functions : calendar, alarm and
a temperature display. The user can also choose between 12h- and 24h-mode for the time
display. We are confident that this multifunctional wall clock will satisfy even the most
demanding of users.
2. Features
Display in Normal Mode : Hours, minutes, date, month, weekday and temperature are
Alarm/Snooze Mode
Thermometer
Time Display Mode
THE NORMAL TIME DISPLAY, THE CALENDAR, THE YEAR AND THE ALARM TIME WILL
BE RESET WHEN THE USER REPLACES THE BATTERIES. YOU CAN ALSO PRESS THE
YELLOW "RESET BUTTON" AT THE BACK OF THE DEVICE TO RESET THESE
FUNCTIONS.
3. Setting the Correct Time
Hold the CLOCK/CAL SET button at the back of the device for 3 seconds to activate the time
setting mode and make the digits for the hours flash. Use the UP- and DOWN-buttons at the
back of the device to enter the hours. Press CLOCK/CAL SET to confirm the hours and make
the digits for the minutes flash. Use UP and DOWN again to enter the minutes and confirm with
CLOCK/CAL SET. The digits for the year start to flash. Use UP and DOWN to enter a year
between 1999 and 2048 and confirm with CLOCK/CAL SET. The digits for the month start to
flash. Enter the month with UP and DOWN and confirm with CLOCK/CAL SET. The digits for
the date start to flash. Enter the date with UP and DOWN and press CLOCK/CAL SET to
confirm the date. The device will automatically return to the normal display mode.
Note that the display for day of the week will automatically be adjusted according to the entered
date.
4. Setting the Alarm
a. Press the ALM SET button once to display the current alarm time for ± 10 seconds.
b. Use the following procedure to alter the alarm time :
Hold ALM SET for 3 seconds to enter the alarm setting mode and make the digits for the
alarm time flash. Enter the hours with UP and DOWN and confirm with ALM SET. The digits
for the minutes start to flash. Enter the minutes with UP and DOWN and confirm with ALM
SET. The device automatically returns to the normal display mode. Arm the alarm by pressing
the ALM ON/OFF button at the back of the device. The
when the alarm is set.
c. The alarm will be activated for one minute at the appropriate time. There are three ways of
stopping the alarm when it goes off :
WC32TC
displayed. The device can also display the year (from 1999 to 2048).
: Daily activation of the alarm and/or the snooze function. Enter the
hours and minutes for the alarm. The snooze function has an
activation delay of five minutes.
: Temperature is displayed in either °C or °F.
: 12h- or 24h-mode.
symbol appears on the screen
1 VELLEMAN