Kenwood DNX210EX Manuel D'installation page 4

Masquer les pouces Voir aussi pour DNX210EX:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Connection
If you connect the ignition wire (red) and
the battery wire (yellow) to the car chassis
(ground), you may cause a short circuit, that
in turn may start a fire. Always connect those
wires to the power source running through
the fuse box.
Connect to the terminal that is grounded when either the telephone
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
|
4
DNX210EX
Parking sensor wire Junction cable
(Light Green) (Accessory 2)
For the sake of safety, be sure to
connect the parking sensor.
Connect to the vehicle's parking brake
detection switch harness using the
supplied relay connector.
Ignition key
switch
Car fuse box
(Main fuse)
+
Battery
rings or during conversation.
Depending on what antenna you are using,
When using the optional power amplifier,
connect to its power control terminal.
If no connections are made, do not let the cable come out from the tab.
GPS Antenna
(Accessory 3) (page 9)
ACC
Ignition wire (Red)
Battery wire (Yellow)
Car fuse box
Ground wire (Black) - (To car chassis)
TEL mute wire (Brown)
Motor antenna control wire (Blue)
Power control wire (Blue/White)
GPS Antenna input
Parking sensor wire
(Light Green)
Remote control
(Light Blue/Yellow)

Publicité

Table des Matières
loading

Table des Matières