Checking The Battery Before Using It For The First Time; Battery Care - FITFIU FITNESS VINTAGE Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

1
There is an LED indicator on the battery charging unit. The LED is red when the power is connected and the battery
is charging. When the LED is green, the battery is full. The recommended charging time is 4-6 hours. Do not charge
continuously for more than 18 hours at a time. The battery charger must have a constant voltage. Fluctuating voltage
or fluctuating power supply of any type can damage the battery storage cells.
After charging, first unplug the input plug (from the wall socket), then unplug the output plug (from the bicycle).

CHECKING THE BATTERY BEFORE USING IT FOR THE FIRST TIME

The battery is supplied partially charged. To ensure battery capacity, fully charge the battery before using it for the
first time.

BATTERY CARE

Even with proper care, rechargeable batteries don't last forever. Each time the battery is discharged and
subsequently recharged, its relative capacity decreases by a small percentage. You can maximize your battery
life by following the instructions in this guide.
The battery should be fully charged immediately after receiving the recommended charging times: Recommended
charging time: 4-6 hours.
For 100% full charge, leave the battery in the charger for one full hour after the charger indicator light is green.
Never charge batteries for more than 24 hours.
Lithium-ion batteries have no memory. Partial discharge/charging cycles will not damage the capacity or
performance of the batteries.
The nominal output capacity of a battery is measured at 77ºF (25ºC). Any variation in this temperature will alter
the performance of the battery and shorten its service life. High temperatures especially reduce battery life and
operating time.
Always be sure to turn off the bike's power switch after each use. If you leave the power switch in the "ON"
position, or if your product has not been charged for a long period of time, the battery may reach a state where
it will no longer be charged.
INSERTING, UNLOCKING AND REMOVING THE BATTERY
Insert the key into the keyhole
Turn the key switch to the ON position when riding the electric bicycle.
Turn the key switch to the OFF position when you stop using the electric bicycle.
Press the key and turn the key switch to the UNLOCK position, the battery is unlocked and can be removed.
TURN OFF
PRESS
2
TURN ON
UNLOCKING
60

Publicité

Table des Matières
loading

Table des Matières