Gearshift Lever; Charging The Battery - FITFIU FITNESS VINTAGE Manuel D'utilisation

2. Starting with the pedal: After starting it, position yourself on the electric bicycle and check that there is no
level of assistance marked on the display, start pedaling to start your electric bicycle, then you can control
the bicycle by its pedaling speed, if you pedal fast the speed of the bicycle will be faster. Please note that
excessively hard pedalling can damage the components of your electric bicycle.
SAFE MOUNTING
Riding carefully on the road
1. The speed should be increased slowly after start-up. We recommend starting the pedal if you want to save
energy or if electrical components are damaged.
2. Use your electric bicycle in pedal assist mode when climbing hills to extend the life of your battery and
engine.
3. Try to avoid frequent braking and starting while driving in order to save energy.
4. To stop the electric bicycle, you can switch off the assistance mode by pressing the "M" key for a long time to
switch off the display or reduce the assistance level to 0. Do not accelerate and brake at the same time while
riding, as this will overload the engine and damage some of the components of the electric bicycle. Instead,
turn off the attendant first and then brake.

GEARSHIFT LEVER

Some FITFIU electric bikes come with change, which consists of:
•
A group of rear sprockets, (set of gears)
• A rear derailleur
• A shift lever
•
A control cable
• A toothed front plate
• A transmission chain
With a larger rear development, it's easier to pedal. For example, you can shift up a gear to make it easier to pedal on
a hill. On the other hand, you can lower the gear to a lower gear when you want to go faster. Whether up or down, the
shift system requires the drive chain to move forward and be at least under some tension. The front derailleur will only
work properly if it is pedaling forward.
ATTENTION: Never move the derailleur while pedalling backwards. Also, do not pedal backward
after shifting. Any of these actions could jam the chain and seriously damage the electric bicycle.
PARKING
1. Turn off the display when getting off the electric bicycle to avoid accidents by inadvertently activating the
wizard.
2. Turn the power key OFF and remove the key after parking.

CHARGING THE BATTERY

Charge the battery directly after your trip is over or if the battery is running low. Charging methods can be divided into
two types, remove the battery to charge it (tilt the unlocked saddle and press the battery key to turn the battery to the
"UNLOCK" position. After this you can either grab the handle and remove it (1) by stretching it upwards, or alternatively
charge it directly from the electric bicycle (2).
Connect the charger connector to the bicycle and a 100-240V / 50-60Hz power supply.
ELECTRIC BICYCLE VINTAGE
59
EN