FITFIU FITNESS VINTAGE Manuel D'utilisation page 54

STEP 2. Place the front wheel axle between the front fork (5) and fit the brake disc between the brake pads located
on the left side (6), once installed place the wheel pin through its axle (7) and adjust it by screwing on both sides and
closing the lever (8).
5 6
7 8
STEP 3. Position the mudguards by inserting the enabled hole from the front and pressing the rods through the fork
(9). Remove the front screw from the front of the fork (10) and align them with the mudguard hole and front light. Fit and
tighten the screw and nut through them to secure them (11). Connect the mudguard rods to the corresponding side holes
of the fork, where the star screws (12) are located.
10
9
11 12
STEP 4. Place the seat post at the desired height (13). Secure the seat by means of the lock (14). The seat is tilted
forward to facilitate the removal of the battery (15), to lock it use the key and lock the saddle lock.
13 14
15
54