Error Codes - FITFIU FITNESS VINTAGE Manuel D'utilisation

• P10. Configuration of the drive mode:
- 0: Assistance (the specific gear of the assistance unit decides the value of the assistance power).
•
P12. Attendance starting current: Range 0-5.
• P13. Magnetic steel energy plate type: 5, 8, 12 (three types).
• P14. Regulator for the current limit value to be set: Range 1 - 20A (12A by default).
• P16. ODO value: Hold down the "+" key for 5 seconds to reset it.

ERROR CODES

Codes
E00 • Standard
E01 • Reserved
E02 • Brake
E03 • PAS Sensor Failure (riding mark)
E04 • Cruise at 6km/h
E05 • Real-TimeCruise
E06 • LowBattery
E07 • Motor Failure
E08 • Throttle Failure
E09 • Controller Failure
E10 • Communications Receiving Failure
E11 • Communications Sending Failure
E12 • BMS Communications Failure
E13 • Light Failure
MOUNTING METHOD
Be familiar with all electric bicycle spare parts and check all electric functions before riding. Make sure all spare parts
for your bike are in good condition. Check tyre pressure and battery power.
HOW TO SET IT IN MOTION
Insert the key into the switch on the left side of the battery box. Turn the "ON" button, and turn on the display screen.
1. To start with the assistance accelerator: Position yourself on the saddle, select the desired level of assistance,
grasp the handlebars before placing your feet on the pedals. Start pedaling and the assistance activator will
start automatically. It is recommended to start with a low level and increase the levels to avoid losing control
of the electric bicycle. If there is no marked level, the bike will work as standard.
Meaning
58
Notes