Installation Instructions - König Electronic SEC-SA200 Mode D'emploi

11. Placing the 1.5 V AA batteries
Take off the plastic seal of the 1.5 V AA batteries and place
the 1.5 V AA batteries in the battery compartment. Place the
1.5 V AA batteries conforming to the polarity markings inside
the battery compartment.
After placing the battery, use the test button to see if the smoke alarm works properly.
(See Testing the smoke alarm.)
When the mounting plate is mounted on the ceiling and the smoke alarm is tested after inserting the
batteries, place the smoke alarm on the mounting plate by turning it clockwise.
See the following chapter for where to mount the smoke alarm(s).

Installation instructions:

Install a smoke alarm in every room or area on every level of the home.
Smoke may not reach the smoke alarm if it's installed in only one room or area. If a fire starts in another
room or area to where the smoke alarm is installed, the smoke alarm will not detect the smoke, or will detect
it too late to alert the household members. A smoke alarm will not promptly detect a fire except in the room
or area in which it is installed.
Place at least one smoke alarm in every room/area between the bedroom and the exit of the house.
We recommended that you make an emergency escape plan, and practice this with the members of your
household, in case of an emergency.
The requirements for the installation of the smoke alarm may differ slightly by region. Please contact your
local authorities for any additional requirements.
5