Before Using For The First Time - Siemens LF259RB51 Notice De Montage Et Mode D'emploi

the appliance after removal of the filter
frame.
Before undertaking any repairs,
always disconnect the extractor hood from
the electricity supply.
Length of the connecting cable: 1,3 m.
If it is necessary to wire the extractor
hood directly into the mains:
The extractor hood should only be
connected to the electricity supply by a
properly qualified electrician.
A separator must be installed in the
household circuit. A suitable separator is a
switch that has a contact gap of more than
3 mm and interrupts all poles. Such
devices include circuit breakers and
contactors.
If the connection cable for this
appliance is damaged, the cable must be
replaced by the manufacturer or his
customer service or a similarly qualified
person in order to prevent serious inury to
the user.
This extractor corresponds to EC
regulations concerning RF interference
suppression.
Installation
The island extractor hood is designed to
be fitted to the kitchen ceiling or a rigid
suspended ceiling.
Ensure that the minimum distance
between hotplate and extractor hood is
550 mm for electric hotplates and 650 mm
for gas hotplates.
Ensure that the inox surface is not
damaged.
Follow the mounting steps as shown in M
Figures.
14

Before using for the first time

Important notes
The instructions for Use apply to
several version of this appliance,
Accordingly you may find description
of individual features that do not apply
to your specific appliance.
This extractor hood complies with all
relevant safety regulation.
Repairs should be carried out by
qualified technicians only.
Improper repairs may put the user
at considerable risk.
Do not flambé food directly under the
extractor hood.
! Risk of grease filter catching fire due to
flames.
The hotplates must always be covered
with a utensil.
Restrictions apply to the use of the
extractor hood over a solid-fuel burner
(coal wood, etc.) (See "Installation"
instructions).
Do not use the appliance if damaged.
The appliance must be connected to
the mains by a qualified technician only.
This extractor hood is designed for
domestic use only.
Light bulbs must always be fitted when
the extractor hood is in use.
Defective bulbs should be replaced
immediately to prevent the remaining
bulbs from overloading.
Never operate the extractor without a
grease filter.
Overheated fat or oil can easily catch
fire. If you are cooking with fat or oil, e.g.
chips etc. never leave the cooker
unattended.