Replacing The Light Bulbs; Before You Call For Service - Dacor Distinctive DTO127 Mode D'emploi

Replacing the Light Bulbs

WARNING
• To prevent an electric shock hazard and/or personal injury,
make certain that the oven and light bulb(s) are cool and that
power to the oven has been turned off at the main power
supply before replacing the light bulb(s).
• Always make sure the lens covers are in place when using
the oven(s). The lens covers protect the light bulbs from
breakage caused by high oven temperatures or mechanical
shock.
• Replacing the lens cover without lining up the cutout with the
light socket will damage the light fixture.
• Do not use a screwdriver to remove the lens.
Light bulb replacement is considered to be a homeowner
maintenance operation. If all the lights do not work,
before replacing them, please consult the Problem Solu-
tion Guide on page 18.
IMPORTANT
Do not touch the replacement halogen light bulbs with
your fingers. Halogen bulbs are sensitive to the oils
from your hand. The oils from your hand will stick to
the bulb and cause it to burn out faster than normal.
Problem Solution Guide
Problem
Nothing works.
Oven will not heat.
Foods over or under cook.
Care and Cleaning

Before You Call for Service

May Be Caused By
Oven not connected to power.
Power to oven is off.
Control panel locked.
Power outage.
Oven setting not correct.
Oven set for delay timed cooking.
Attempting to broil with the meat
probe connected.
Incorrect cooking time or tempera-
ture.
To replace the light bulbs...
1. Replace the light bulb only with Dacor part number
107112 (120 Volt 20 Watt). Visit www.everythingda-
cor.com for ordering information.
2. Turn off power to the oven at the circuit breaker panel
or fuse box.
3. Hold your hand under the lens for support and gently
pry it loose using a spatula or table knife. Pull the lens
cover straight out.
4. Grasp the old bulb and pull it straight out of the
socket.
5. Using a glove, insert the new bulb into the socket.
6. As you reinstall
the lens cover,
line up the
cutout on the
inside rim with
the light socket.
Gently press it
into its original
position.
7. Turn the power
to the oven back
on at the main
power supply.
8. Reset the clock
(see page 5).
Have a licensed electrician connect oven to
properly wired electrical connection.
Turn on power at circuit breaker or fuse box.
Check for tripped breaker or blown fuse.
Touch CANCEL · SECURE key for six seconds
to reactivate control panel
Contact power company
Touch CANCEL · SECURE, then follow instruc-
tions in Operating the Oven section.
Oven will turn on automatically at preset time.
Touch CANCEL · SECURE to return to normal
operation.
Broil and convection broil settings will not
work when meat probe is connected. Discon-
nect meat probe.
Follow instructions in Operating Your Oven
section.
18
Light socket
Light bulb
Cutout on
inside rim of
lens
What to Do