Zanussi ZDT16017FA Notice D'utilisation page 20

German
degrees
(°dH)
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the water
softener
1. Press the on/off button to activate the ap-
pliance. Make sure that the appliance is in
setting mode, refer to "Setting and starting
a programme".
2. Press and hold, at the same time
until the
start to flash.
3. Press button
• The indicators of buttons
go off.
• The indicator of button
flash.
• The display shows the current setting of
the water softener, e.g.
4. Press button
change the setting.
5. Press the on/off button to deactivate the
appliance and to confirm the setting.
Filling the salt container
Caution! Water and salt can come out
from the salt container when you fill it.
Risk of corrosion. To prevent it, after you fill
the salt container, start a programme.
20
Water hardness
French mmol/l
degrees
(°fH)
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7
, and indicators
.
and
continues to
= level 5.
again and again to
Clarke
degrees
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 0.7 < 5
and
1
3
Put 1 litre of water in
the salt container
(only for the first
time).
Water softener
adjustment
Level
6
1)
5
4
3
2
2)
1
2
4
www.zanussi.com