HK Audio ELEMENTS GALA Manuel D'utilisation page 5

Note: Be sure to rotate speaker connectors clockwise until they lock in
place!
Heads up: This type of connector has to be turned clockwise until it
engages. It also has to be disengaged before it can be unplugged. To this
end, pull the bayonet catch towards the cord and turn the connector
counter-clockwise.
●
12
Mains
Use the factory-included mains cord to connect this
socket to a wall outlet.
Heads up: The GALA SUB 15 subwoofer comes
with a V-Lock mains socket. It lets you fi x the
included V-Lock mains cord in place to prevent
accidental disconnection.
Caution! Make sure the local mains voltage
matches the voltage specifi ed on the GALA SUB 15 subwoofer.
Connecting it to the wrong mains voltage may destroy its electronic
components.
●
13
Speaker Input on the EF 45 Base
(not pictured)
To connect the two mid/high columns to the subwoofer, plug one end of
each of the two included speaker cables into the speaker input jacks on the
EF 45 base and the other into the subwoofer's Mid/High Out L/R outputs,
●
11
respectively ( ). The E-Connect bus routes the signal to the connected
mid/high units. You can, of course, assemble columns without the EP 2
extension poles.
E 835
E 835
EP 2
EF 45 GALA SUB 15
3 Setting Up and Connecting the
Column's Components
3.1 E-Connect
E-Connect is a fast, reliable and cordless way of linking the ELEMENTS
GALA's passive components. This dual-purpose coupler provides physical
Mains
and audio links that connect the E 835 mid/high-units, the EP 1 speaker
extension pole and the EF 45 base.
1.7 A rated current
3.2 Connecting the Column's Components
Line up the two components so that the pole end faces the sleeve. Insert
12
the pole end all the way into sleeve until the detent button snaps into
place, making sure you have a solid connection.
To disconnect and separate the units, press and hold the button on the E-
Connector to release the detent and then pull the two components apart.
E 835
Heads up: Always set the system up on fl at, level and fi rm surfaces.
4 Powering Up
• Make sure the GALA SUB 15 bass bin is switched off when you're setting
up; otherwise, the system may be damaged. Turn the Bass Gain knob to
the 0 dB center-notched position.
• Always set up the entire system and connect all cables before you switch
E 835
the GALA SUB 15 bass on.
• Always switch off the GALA SUB 15 fi rst when taking the system down.
EP 2
EF 45
Push!
Pull!
ELEMENTS GALA 1.0b
5