EMB COD18 Guide Utilisateur page 8

Registering with the SC28 Home Protector
1. Set the detector to the correct mode, being Remote or Sensor.
2. Access the menu of the console, done by either using the menu UP or DOWN
The display now shows ENTER PIN.
3. Enter your PIN; factory default is [0000]: The display is cleared and shows a * for each
number entered.
4. When the PIN code has been entered correctly, the word INSTALL will show up on the
display.
5. Press OK.
6. Press the TEST button on the Detector. The console will beep to confirm. The display will
either read ZONE 1 SET (when sensor mode was set) or RMOT 1 SET (when remote mode was
set).
A memory space for a sensor is called a zone. If you have more than 1 sensor installed, they
will be shown e.g. ZONE 2 SET, ZONE 3 SET, ... ZONE 30 SET.
You can choose in which zone you want to install the sensor. If you want to install the sensor
in zone 3, press 3 on the number pad before executing step 5.
It's advisable to write down which zone contains which sensor. There is space reserved at the
back of this User Manual.
7. Repeat step 5 for every Detector you wish to register.
8. Press CLEAR to go back to the first menu item. Press CLEAR again to quit the menu. To
confirm this choice, press 1 for Yes or 2 for No. If you choose Yes, you will quit the menu. If you
choose No, you go back to the first menu item.
Registering with the BS800 HomeGuard
1. Set the detector to the correct mode, being Remote or Sensor.
2. Access the menu of the console, a PIN will be requested.
3. Enter your PIN, factory default is [0000]: You will hear three high tones and one low tone as
confirmation. The green indicator starts flashing.
4. Press 1 on the keyboard of the HomeGuard; One high tone is given for confirmation.
5. Press the test button of the sensor; One low tone is given for confirmation.
6. Repeat step 1-3 for every Detector you wish to register.
7. Press any button on your HomeGuard keyboard to finalise the registration procedure. One
short low tone is given and the green indicator will stop flashing.
If successive commands are not entered within a period of 15 seconds, the base station
returns to normal operation. To restart the registration you must start the procedure from
step1.
NOTE. The RF range can be affected by a number of factors including building construction,
so make sure you test the detector in the desired location using the detector's main test
button.
The detector will sound an alarm and when in range the console will also acknowledge the
detector.
10-9-2008 8
button.
RF Sensors