EMB COD18 Guide Utilisateur page 43

Addendum Gas, CO, Smoke and Water detectors - Important Notice!!
However stated different on the supplied manual, this detector can only be registered in
Remote mode!
In Remote mode, the detector will act as a remote, which means it will always trigger an alarm
as soon as a fault is detected.
The state of the console, being Armed or Disarmed, will make no difference.
Before registering the detector with the console please make sure the switch on the side of the
detector is set to 'R'.
Please follow the registration process as described below:
Registering the Detector with the Console
Registering with the SC28 Home Protector
1. Access the menu of the console, done by either using the menu UP or DOWN button. The
display now shows ENTER PIN.
2. Enter your PIN; factory default is [0000]: The display is cleared and shows a * for each number
entered.
3. When the PIN code has been entered correctly, the word INSTALL will show up on the display.
4. Press OK.
5. Press the TEST button on the Detector. The console will beep to confirm.
The display will read RMOT 1 SET.
A memory space for a detector is called a zone. If you have more than 1 detector installed,
they will be shown e.g. RMOT 1 SET, RMOT 2 SET, ... REMOTE 16 SET.
You can choose in which zone you want to install the detector. If you want to install the
detector in zone 3, press 3 on the number pad before executing step 5.
It's advisable to write down which zone contains which sensor. There is space reserved at the
back of this User Manual.
6. Repeat step 5 for every Detector you wish to register.
7. Press CLEAR to go back to the first menu item. Press CLEAR again to quit the menu. To confirm
this choice, press 1 for Yes or 2 for No. If you choose Yes, you will quit the menu. If you choose
No, you go back to the first menu item.
Registering with the BS800 HomeGuard
1. Enter your PIN, factory default is [0000]: You will hear three high tones and one low tone as
confirmation. The green indicator starts flashing.
2. Press 1 on the keyboard of the HomeGuard; One high tone is given for confirmation.
3. Press the test button of the sensor; One low tone is given for confirmation.
4. Repeat step 1-3 for every Detector you wish to register.
5. Press any button on your HomeGuard keyboard to finalise the registration procedure. One
short low tone is given and the green indicator will stop flashing.
If no commands are not entered within a period of 15 seconds, the base station returns to
normal operation. To restart the registration you must start the procedure from step1.
10-9-2008 43 RF Sensors