Automatic Cooking - Fisher&Paykel OR24SDPWSX Guide D'utilisation

5
2
3
24

AUTOMATIC COOKING

Start cooking at the programmed time and switch the oven off
automatically after the programmed cooking time.
Setting
1.
Set the cooking function by turning the oven selector to the function required.
2.
The cooking temperature appears on the display. To change it proceed as described
in the Setting the cooking chapter.
3.
Press pushbutton 2.
4.
Press pushbuttons 5 or 6 to set the cooking time (cooking time in hours and min-
utes: set it to ten minutes less than the time required because the stored heat will
5 6
complete the cooking).
5.
On the display
6.
Press pushbutton 3 (
7.
5 6
Press pushbuttons 5 or 6 to set the time when the cooking should finish.
The values set must be correct; e.g. if it is 08:00 a cooking time of 3 hours, ending
at 10:00, cannot be set. In this case the programmer automatically sets the end of
cooking time for 11:00.
8.
On the display
symbol goes out.
Starting cooking
9.
The pan symbol lights up. The oven switches on and the cooking cycle set starts.
During cooking
10.
During the cooking cycle, the display shows the oven temperature measured by
the probe or pre-setted temperature.
Press key 2 to display the length of cooking set.
Press key 3 to display when the cooking will finish.
The cooking time, end of cooking time and cooking temperature can be varied at
any time, as described above.
At the end of cooking
11.
End
The cooking cycle has finished and the oven is OFF.
13.
Press any pushbutton to stop the audible signal.
14.
OFF
15.
Turn the function selector to
16.
The programmer display shows the time.
Note: At the end of the programme always turn the function selector
knob to OFF (oven OFF).
IMPORTANT: During AUTOMATIC COOKING PROGRAM the oven light
is always on, also before starting (heating elements on or cycling) of the
programmed cooking.
AUTO
starts to flash and
AUTO
becomes steady and the cooking programme starts.
AUTO
starts to flash).
AUTO
becomes steady and the time appears again. The cooking
AUTO
appears on the display,
appears (oven OFF).
OFF
0.00
appears.
flashes and the audible signal sounds.
(oven OFF).