Operating Principles - Fisher&Paykel OR24SDPWSX Guide D'utilisation

how to use the self cleaning oven
GENERAL FEATURES
The oven has special operating features.
Five different functions can be used to satisfy all cooking needs; it also has a self clean-
ing function which can clean the oven cavity at high temperature, a defrost function
and an oven light function.
These functions are managed by an electronic programmer which keeps the tempera-
ture set constant by means of a probe inside the oven cavity.
The ovens have the following heating elements:
- Lower heating element (double) 500 + 1300 W
- Upper heating element
- Grill heating element
- Circular heating element
USING THE OVEN FOR THE FIRST TIME
- Put in the shelf and the tray.
- Switch the oven on empty (on a cooking function – NOT SELF CLEANING) at maximum
power for about 2 hours to remove traces of grease and smells from the components.
- When the oven has cooled down and unplugging the range, clean the inside of the oven
with a cloth soaked in water and neutral detergent and dry it perfectly.
WARNING:
The door is hot, use the handle.

OPERATING PRINCIPLES

Heating and cooking in the multifunction self cleaning oven takes place as follows:
• by normal convection
The heat is produced by the upper and lower heating elements.
• by forced convection
The heat produced by the circular element is distributed throughout the oven by the
fan.
• by radiation
The heat is radiated by the infra red broil element.
• by radiation and fan
The radiated heat from the infra red broil element is distributed throughout the oven
by the fan.
• by double radiation and fan
The fan distributes the heat radiated by the broil heating element and the upper heat-
ing element in the oven.
• by ventilation
The food is defrosted by using the fan only function without heat.
• by self cleaning
The heat produced by the heating elements cleans the internal oven cavity removing
all residue of grease.
THIS IS NOT A COOKING FUNCTION
NOTES ON OVEN WORKING
A cooling fan starts automatically when selecting a cooking or self cleaning mode.
It stops when turning the selector knob to OFF or light or defrosting position and
th inside oven cavity temperature drops below 100 °C (212 °F).
The purpose of this fan is to reduce the temperature inside/outside the appli-
ance.
Note: The first time the oven is used or after a black-out the programmer must be
started by pressing keys 2 and 3 simultaneously. See the chapter on the use of the
electronic programmer.
1000 W
2000 W
2200 W
Attention: the oven door becomes
very hot during operation.
Keep children away.
VERY IMPORTANT
The oven shall be used always
with the door closed.
NEVER USE THE RANGE WHEN
THE OVEN IS OPERATING IN SELF
CLEANING MODE.
IMPORTANT:
DURING THE SELF-CLEANING
CYCLE THE VITROCERAMIC HOB
COOKING ZONES DO NOT OPER-
ATE.
If during self-cleaning cycle a
cooking zone control knob has
been turned ON return the knob
to the OFF position. Otherwise at
the end of the self-cleaning cycle
and after having turned the oven
selector control knob to the OFF
position, the cooking zone will
operate.
WHEN THE SELF CLEANING MODE
HAS BEEN COMPLETED:
• do not start immediately a new
self cleaning cycle: LET THE RAN
GE TO COOL DOWN.
IMPORTANT:
DURING THE SELF-CLEANING
CYCLE THE WARMING DRAWER
DO NOT OPERATES.
If during self-cleaning cycle the
warming drawer control knob has
been turned ON return the knob
to the OFF position. Otherwise
at the end of the self-cleaning
cycle and after having turned the
oven selector control knob to the
OFF position, the warming drawer
will operates.
I I I I I I I I I
2 3
4
11