Important Warning - Fisher&Paykel OR24SDPWSX Guide D'utilisation

Cuiseur indépendant
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TIMER
The timer function is only used to count the time and does not influence oven operation
or any programmes which are in progress or set.
1.
Press pushbutton 1. The bell symbol will start to flash.
2.
Press keys 5 or 6 to set the time required.
3.
The countdown starts immediately. The bell symbol stops flashing and the time
appears again.
4.
To see the countdown press pushbutton 1. The time will be indicated in hours and
minutes; the seconds are only indicated for the last minute.
5.
At the end of the countdown an audible signal sounds and the bell symbol on the
display flashes.
Press any pushbutton to stop the audible signal.
IMPORTANT WARNING: This function is only an electronic alarm and does not
switch OFF the oven. Remember to turn OFF manually the selector knob at the
end of the countdown.
SEMI-AUTOMATIC COOKING
Start immediate cooking and switch the oven off automatically
after the programmed cooking time.
Setting
1.
Set the cooking function by turning the oven selector to the function required.
2.
The cooking temperature appears on the display. To change it proceed as described
in the Setting the cooking chapter
3.
AUTO
Press pushbutton 2.
4.
Press pushbuttons 5 or 6 to set the cooking time (cooking time in hours and min-
utes: set it to ten minutes less than the time required because the stored heat will
complete the cooking).
5.
AUTO
On the display
During cooking
6.
During the cooking cycle, the display shows the oven temperature measured by the
probe or pre-setted temperature.
Press key 2 to display the time remaining until the end of cooking.
The cooking time and temperature can be varied at any time, as described
above.
At the end of cooking
7.
End
appears on the display,
The cooking cycle has finished and the oven is OFF.
8.
Press any programmer pushbutton to stop the audible signal.
9.
OFF
appears (oven OFF).
10.
Turn the function selector to
11.
The programmer display shows the time.
Note: At the end of the programme always turn the function selector
knob to OFF (oven OFF).
0.00
starts to flash and
becomes steady and the cooking programme starts.
AUTO
flashes and the audible signal sounds.
OFF
(oven OFF).
appears.
1
5
6
2
5
6
5
23

Publicité

Table des Matières
loading

Table des Matières