Technical Characteristic Tables - De Dietrich DTE1110W Guide D'installation Et D'utilisation

TECHNICAL CHARACTERISTIC TABLES

BURNERS
N° DESCRIPTION
RAPID
1
SEMI-RAPID
2
AUXILIARY
3
TRIPLE
4
CROWN
This product complies with EU Directive 2002/96/EC.
The crossed-out dustbin symbol reported on the appliance indicates that the appliance
must be disposed of separately from other domestic refuse at the end of its useful life.
It must therefore be delivered to a waste recycling centre specifically for electric and
electronic equipment or returned to the retailer at the moment of purchase of a new
equivalent appliance.
The user is responsible for delivering the appliance to the appropriate collection centre at the end of its
useful life, Failure to do so may result in a fine, as provided for by laws governing waste disposal.
Differential collection of waste products for eventual recycling, treatment and environmentally friendly
disposal helps reduce possible negative effects on the environment and health, and also enables the
materials making up the product to be recycled.
For more detailed information on the available refuse collection systems, refer to the local Municipal Solid
Waste disposal centre or the shop where the product was purchased.
Producers and importers are responsible for fulfilling their obligations as regards recycling, treatment and
environmentally friendly disposal by directly or indirectly participating in the collection system.
The manufacturing firm refuses all responsibility for any possible imprecision in this booklet, due
to misprints or clerical errors. It reserves the right to make all the changes that it will consider
necessary in its own products, without effecting the essential characteristics of functionality and
safety.
NORMAL
PRESSURE
GAS
mbar
G30 / G31 28 - 30 / 37
G20 20
G30 / G31 28 - 30 / 37
G20 20
G30 / G31 28 - 30 / 37
G20 20
G30 / G31 28 - 30 / 37
G20 20
NOMINAL INJECTOR
RATE DIAMETER
g/h L/h 1/100 mm
225 - 85
- 290 115Y
126 - 65
- 165 97Z
71 - 50
- 99 72X
278 - 98
- 367 135K
10
TAPE BY NOMINAL
PASS HEAT INPUT
DIAMETER (W)
1/100 mm Max.
42 3000
Reg. 3000
31 1750
Reg. 1750
27 1000
Reg. 1000
60 3800
Reg. 3800
Min.
950
950
600
600
450
450
2100
2100