TFK lite mini Notice D'utilisation page 9

OPERATING AND ASSEMBLY MANUAL
• (Fig. I) In order to be able to use the Lite Mini, always first fold the
lower section of the frame open. Press the basket frame (1)
downwards with the hand or the foot, until it audibly locks into place.
This is extremely important for stability.
• (Fig. II) Then swivel the push bar (2) upwards until the red double
lock (3) locks into place. Then close the locks (4) on the left and right
over the folding joint
• (Fig. III) Before assembling the seat, you have to remove the basic
adapters. The seat is mounted to the frame with 3 push buttons (a)
on each side of the frame. Additionally, it's fixed to the foot rest with
2 pushbuttons (b). On each side of the seat, there're 2 push buttons
(c) where the wind protection of the hood are fixed.
• (Fig. IV) Insert the hood (5) on the left and right into the holders (6) on
the push bar (2). It is then secured with on the backrest with four push
buttons (d).
- (Fig.V) For the assembly of the rear wheels, push the axle (6)
through the rear wheel mount until it audibly locks into place. If you
want to remove the wheels, press the red button (7).
- (Fig.VI) Insert the front wheel (9) into the provided wheel mount (10)
until it audibly locks into place. If you press the red button of the
mount (10), you can remove the wheel downwards. In order to
locate the rotatable rear wheels (9), press the light grey arresting unit
of the wheel mount (10) downwards.
• (Fig. VII) The backrest can be adjusted in four different ways using
the lateral zips (16). Make sure that they are always either fully open
or fully closed.
- (Fig.VIII) The foot board (13) can be folded upwards. To this end, it
must be locked in place with the foot rest (14).
• (Fig. IX) A mosquito net (20) is rolled into the hood bar. Open the
zip and pull it taut downwards over the footrest. By opening another
zip, you can also remove the net completely.