Applications; Conformity And Approval - IMG STAGELINE TXS-606DT/2 Mode D'emploi

1
Wireless Desktop Microphone
These instructions are intended for users without
any specific technical knowledge . Please read these
instructions carefully prior to operation and keep
them for later reference .
1 Important Notes
The wireless microphone corresponds to all relevant
directives of the EU and is therefore marked with
•
The microphone is suitable for indoor use only .
Protect it against dripping water, splash water and
high air humidity . The admissible ambient temper­
ature range is 0 – 40 °C .
•
For cleaning only use a dry, soft cloth; never use
water or chemicals .
•
No guarantee claims for the microphone and no
liability for any resulting personal damage or ma­
terial damage will be accepted if the microphone
is used for other purposes than originally intended,
if it is not correctly operated, or if it is not repaired
in an expert way .
If the microphone is to be put out of oper­
ation definitely, dispose of the microphone
in accordance with local regulations .
6
2 3 4 5
IR
L H - VOLUME +
GROUP CHANNEL
BATT
TXS-606DT/2
WIRELESS DESKTOP MICROPHONE
6
MUTE
7
2 Overview
1 Connection for the gooseneck microphone
2 Switch to select the transmitting power
L = Low: transmitting power (2 .5 mW)
H = High: transmitting power (25 mW)
3 Sensor for the infrared signals from the receiver
for automatic channel setting
4 Control to set the microphone sensitivity
5 Display
6 LED MUTE; will light up when the microphone has
been muted by means of the button (7)
7 Button to switch on / off and to mute the micro­
phone
To switch on, mute / unmute: Briefly press the
button .
To switch off: Keep the button pressed until OFF
appears on the display .

3 Applications

Combined with the following receivers from IMG
STAGELINE, this wireless desktop microphone
creates a wireless audio transmission system that
can be used as a conference system, for example .
TXS­606 (1 receiver unit)
TXS­626 (2 receiver units)
TXS­646 (4 receiver units)
TXS­686 (8 receiver units)
Frequency setting via the ACT function (Automatic
Channel Targeting) is a most convenient feature:
Simply press a button to set the wireless microphone
via IR signal to the channel selected on the receiver .
.

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare that
the product TXS­606DT/ 2 complies with the directive
2014 / 53 / EU . The EU declaration of conformity is
available on the Internet:
www .img­stageline .com
Restrictions or requirements apply in the fol-
lowing countries:
CZ
IT
The regulations of the country where the product
is operated must always be observed . Prior to op­
erating the product, please contact the MONACOR
subsidiary or the corresponding authorities of the
respective country . Links to the national authorities
can be found via the following Internet address:
EL FI FR
LT MT PL