Tips And Advice; Cleaning And Maintenance; Safety Advice - Bartscher 135.105 Mode D'emploi

•
If the beverage is mixed properly, turn the switch to the position marked „O" (OFF)
and remove the shaker, lifting it slightly up by the handle.
•
Pour the beverage out from the shaker and serve.
•
Remove the plug from its socket if the unit is not to be used any longer.

Tips and advice

•
Most beverages can be prepared in less than two minutes.
•
When preparing fruit cocktails never use whole fruits but rather chopped fruit or pulp.
•
The shaker must always be filled to the minimum filling volume mark, so that the
mixing tip can properly mix the beverage.
•
When preparing drinks of a thinner consistency, do not exceed the maximum filling
volume mark to avoid spilling of the beverage while mixing.
•
For best results, use chilled ingredients. Milk cocktails are best if prepared using cold
milk. The colder the milk, the thicker and foamier the beverage will be as a result.
•
Syrups and powders should be added directly prior to mixing so that they do not sink
to the bottom of the shaker.
•
Fill the shaker first with liquids, then solid ingredients.
•
Begin mixing at speed „1" (slow), before changing to speed „2" (fast).
•
The bar mixer is not intended for grinding ice. When making drinks, use crushed ice
when ice is necessary.

6. Cleaning and maintenance

6.1 Safety advice

o Before beginning with repair or cleaning works make sure the device has been
disconnected from power socket (pull the power plug!!!) and has cooled down.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables and the
plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets. Therefore, you must not
use any kind of pressure water jet for cleaning the device!
- 22 -