Operating - Bartscher 135.105 Mode D'emploi

•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.3 Operating

•
Clean the unit prior to use (see 6.2 „Cleaning").
•
Insert the unit's plug to a single grounded outlet.
•
Ensure the switch is located in the „O" position.
•
Fill the shaker with the desired ingredients.
CAUTION!
While filling the shaker, ensure that the maximum filling volume is not exceeded
(higher mark, approx. 650 ml).
The shaker must not be underfilled, as the mixing tip may not reach the
ingredients. Ensure that the ingredients in the shaker reach the minimum filling
volume mark (approx. 200 ml!)
•
Attach the shaker to the unit. Ensure that the upper edge
is properly attached to the shaker clamp, as this is the
only way to ensure contact between the shaker and micro
switch.
CAUTION!
Use only the shaker supplied with the unit!
•
If the mixing tip is properly attached to the shaker clamp, the bar mixer can be turned
on by using the switch. First, turn the switch to speed „I" (slow), then to speed „II"
(fast).
WARNING! Danger of injury!
Never insert hands, spoons or any other objects into the shaker when the unit is
turned on!
Failure to follow these instructions may lead to serious injuries and cuts caused
by the mixing tip, as well as damage to the unit.
•
Mix the ingredients until the desired consistency is reached (1-2 minutes).
- 21 -