Festo VPPM−Series Notice D'utilisation page 29

VPPM−...
Fastening to a wall or surface
S Fasten the VPPM−... at the intended
position with two M4 screws.
If necessary, use the bracket type
VAME−P1−A (see Fig.). When mounting
the VPPM with the aid of the bracket,
the VPPM−... may only be loaded
statically.
Position of the mounting holes, see Fig.
Tightening torque: 1.0 Nm
Fastening on the sub−base
S Fasten the VPPM−... 2 on the
sub−base 1 type VABM−P1−SF−G18−...
Position of the mounting holes,
see Item 3 in the figure to the right
Tightening torque: 1.5 Nm
Fastening on the H−rail (see Fig. 9)
S Mount the H−rail adapter type VAME−P1−T to the VPPM−... with the aid of the enclosed
screws (Tightening torque approx. 1.0 Nm):
for x": M4 x 65
for ¼": M4 x 75
S Hang the VPPM−... onto the H−rail.
S Secure the VPPM−... with the retaining screws of the H−rail adapter
(tightening torque 1.5 Nm).
Fig. 8
Festo VPPM−... 0607NH English
1
2
3
29