Carat DPSK010000 Manuel D'instruction page 10

*Cups with M14 connection do NOT need base flange.
6. GRINDING
7. WALL GRINDING
5. Set the prroper G-J spacer on the spindle.
6. Set the (k) base flange on the spacer.
7. Place the cup wheel on the (k) base flange.
8. Screw the wheel nut on the cup wheel.
9. Fix the spindle and tighten the wheel nut with the
wrench.
Choose the correct spacer to maintain distences X and Y as
Surely connect the cleaner hose to the exhaust of the
collector, then turn grinder on and start working.
Use (n) adapter as joint between exhaust and cleaner hose.
Loosen the screws and remove the sub cover (b)
And replace by the half cover (c)
Now you can work just against the walls.
10
shown