Door Reversibility - Zanussi ZRG15807WA Notice D'utilisation

Masquer les pouces Voir aussi pour ZRG15807WA:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Authorised Service
Centre.
Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.
Location
CAUTION!
It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and the
wall unit must be at least 100 mm . Ideally,
however, the appliance should not be
positioned below overhanging wall units.
Accurate levelling is ensured by one or more
adjustable feet at the base of the cabinet.
www.zanussi.com
min.
100 mm
15 mm
15 mm

Door reversibility

WARNING!
Before carrying out any operations,
remove the plug from the power
socket.
CAUTION!
To carry out the following
operations, we suggest that this be
made with another person that will
keep a firm hold on the doors of the
appliance during the operations.
1. Unscrew both screws on the rear side.
2. Push back the top and lift it.
3. Unscrew the left foot.
4. Unscrew the screws of the door bottom
hinge. Remove the hinge. Put over the pin in
the direction of the arrow.
53

Publicité

Table des Matières
loading

Table des Matières