Door Reversibility - Zanussi ZRT623W Notice D'utilisation

Location
The appliance should be installed well away from sources
of heat such as radiators, boilers, direct sunlight etc. En-
sure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the appliance
should not be positioned below overhanging wall units.
Accurate levelling is ensured by one or more adjustable
feet at the base of the cabinet.
If the cabinet is placed in a corner and the side with the
hinges facing the wall, the distance between the wall and
the cabinet must be at least 10 mm to allow the door to
open enough so that the shelves can be removed.

Door reversibility

Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.
1. Remove the plug from
the power socket.
2. Open the door of the
freezer. Loosen the hinge.
2
1
3
3. Remove the doors by
pulling them slightly and
remove the hinge.
Warning!
It must be possible to dis-
connect the appliance from
the mains power supply; the
plug must therefore be easi-
ly accessible after installa-
tion.
To change the opening direction of the door, do these
steps:
4. On the opposite side, re-
move the hole covers.
5. Unscrew both adjustable
feet and the screws of the
bottom door hinge. Re-
move the bottom door
hinge and install it on the
opposite side.
21