EQUATION Alutec Manuel D'installation Et D'entretien page 20

Only you can to install the radiator in
ZONE 3.
DO NOT USE THIS HEATER IN THE
IMMEDIATE OF A BATH, A SHOWER
OR A SWIMMING POOL (zone 0, 1 and
zone 2).
1. A suitable location on the wall must be selected. This wall shall be strong and level. Check that there is a mains socket
available nearby.
2. Place the installation template on the wall and mark the locations for the drill holes.
3. Remove the template and drill the required holes in the wall.
4. Install the brackets:
1
4 SCREWS
5. Plug the heater into the nearby mains socket.
3. MAINTAINANCE
- We recommend that all parts of the radiator are kept clean (behind, underneath, upper ns etc.).
- Dust it with a dry and soft cloth when the transmitter is disconnected and is cold.
- Never use disolvents or abrasive products.
- It is convenient to clean the surface of the transmitter at the beginning of the heating season (ALWAYS
BEFORE CONNECTING IT).
The manufacturer reserves the right to modify without previous warning.
ALUTEC1_2014_MOOR@ESPFRUK2014
20
DANGER
2
PLACE THE
RADIATOR
ENGLISH
3
4
3
1
2 SCREWS
1. TO PLACE
2
2. TO LET
3. TO PLACE
SCREW THE
2 SCREWS