Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.7 PROGRAMMING
1) Check that the thermostat is in the Standby position.
2) Press the
button for ve seconds in order to change over to the Programming mode.
3) Select the hourly operating mode by pressing the
4) Press the
button to move on to the next hour or to move through the bands without changing the programming.
Note: the operating mode for the previous hour can be copied by pressing the
5) Repeat the operation for each hour of each day of the week.
On completion of the programming for day 7, the thermostat will automatically save the parameters.
6) Press the
button to (the time is displayed + the day on-screen).
7) Press the
button again to return to the Standby position (TIME).
8) Switch the heater on by pressing the
9) Check that the heater is in the automatic Pro mode. Press the
Note: Check that the time is correctly adjusted.
Important notes:
- In the automatic Pro mode, the selected temperature and the word "Pro" are alternatively displayed on-screen.
- The comfort temperature in automatic Pro will have the value selected in comfort mode. Note: remember that the
economy temperature will always be a maximum of the comfort temperature less 3 ºC. The anti-frost mode temperature
is xed at 7 ºC.
- In automatic mode, the programmed temperature can be changed for any desired length of time, without changing the
programming, by pressing the
- The factory-set program is from Monday to Friday, Comfort from 06:00 to 23:00 and Economy from 23:00 until 06:00.
18
button.
8h
12h
16h
20h
24h
0h
4h
1
2
3
4
5
6
7
1
2
3
4
5
6
7
button.
and
buttons. Remember to return to the previously selected temperature.
ENGLISH
Upper segment: COMFORT
Lower segment: ECONOMY
No segment: ANTI-FROST
button.
button until Pro is displayed on-screen.
Publicité
Table des Matières
